Old riveted steel truss bridge with flaking paint over a river

用海绵喷砂清除桥梁与钢结构上的含铅漆。

用海绵喷砂清除桥梁、钢梁和钢结构上的含铅漆:最多95%的扬尘在作业面被截留,含铅残物集中在一起;与一次性磨料相比,废料体积最多减少90%。

  • -90%

    废料(对比一次性磨料)

  • Sa 2.5

    近白级,SSPC-SP 10

  • 25–110 µm

    粗糙度,通用档

Underside of an old riveted steel truss bridge: girders and cross bracing with faded grey-green lead paint flaking off in
难点

老桥,带着老漆。

许多桥梁和钢结构在后来的涂层下面,仍留有含铅底漆。涂新体系之前,这层漆必须清除到规定的清洁度,通常是SSPC-SP 10近白级,同时不能让铅扩散到整个工地。

这些结构横跨道路、河流和铁路,处在风和车流之中。

于是每一平方米的喷砂都成了围护问题:一种方法产生的粉尘和废磨料越多,密闭围护就要越大,监测越多,危废处置费用越高。

A corroded bridge bearing and lower chord with thick peeling paint layers and rust, road traffic lane on the deck above and
  • 含铅粉尘暴露

    常规干喷砂把含铅粉尘扩散到工人、过往车辆和下方地面。

  • 成吨的危险废物

    一次性磨料与漆渣混在一起,全部都要按危险废物处置。

  • 桥面下的水体

    湿法作业可能让污染废水流入河道和排水系统,涂装前还要等待干燥。

解决方案

把铅控制住的桥梁喷砂磨料。

EcoSponge Blast 海绵磨料像常规磨料一样清除含铅漆、铁锈和氧化皮。载体回弹形成负压,把切削产生的扬尘与细粉截留在颗粒内部,残物随海绵磨料一起回收,再由振筛机把可复用的颗粒与漆的细粉分开。

An operator in orange high-visibility coveralls sponge blasts a riveted bridge girder inside a containment enclosure of
CAPTURE. SORT. REUSE.
  • 从源头抑制扬尘

    最多95%的扬尘在作业面被截留,密闭围护和空气监测更容易管理。

  • 待处置废料更少

    海绵磨料可循环复用5–30次,视档位与压力而定,废料体积最多减少90%。

  • 关于铅,如实说明

    含铅细粉仍属危险废物,必须按危险废物处理。海绵磨料能做的,是让它们的体积更小。

  • 作业区更紧凑

    反弹低,颗粒落在操作人员附近,作业区和围护范围都可以收得更小。

用在哪里

钢结构喷砂,就地完成。

  • Operator sponge blasting a riveted steel girder and gusset plate inside a white tarpaulin containment under a bridge
    桥梁与钢梁
    在项目要求的密闭围护内,逐段清除钢梁、支座和支撑上的含铅涂层,达到SSPC-SP 10 / Sa2.5。
  • Operator sponge blasting the steel members of a lattice tower or stadium roof structure on site, clipped to a harness on a
    钢结构
    塔架、框架、体育场钢结构和工业构筑物在现场处理,不用拆下构件,也不用运到喷砂车间。
  • Operator sponge blasting a concrete bridge pier at the abutment, removing old coating and staining, exposing clean concrete
    混凝土与砌体
    对混凝土桥墩、桥台和桥面做海绵喷砂,清除旧涂层和污渍,打开表面,便于修补砂浆或新涂层附着。
作业流程

从含铅旧漆到新涂层体系。

桥梁施工班组如何用海绵磨料清除含铅漆。

  • A crew builds a tarpaulin containment on scaffolding under a bridge and connects a negative-air filtration unit with a
  • Strip to near-white: close view of the sponge blasting nozzle removing the grey-green lead paint system from riveted steel,
  • Inside the containment a worker shovels swept granules and paint debris into a classifier unit
  • A painter applies red-brown primer with a spray gun on the freshly blasted dry girder inside the containment right after
  • 围护

    搭建密闭围护

    按除铅方案的要求搭建密闭围护、布置监测;低扬尘、低反弹让它运行起来更简单。

  • 喷砂

    清除至近白级

    通用档把含铅涂层体系清除到裸钢,可达SSPC-SP 10;重垢档处理节点处的层状锈。

  • 分离

    回收残物

    海绵磨料和漆渣残物一起归集、筛分。干净的海绵磨料回到喷砂机;含铅细粉装袋,按危险废物处置。

  • 涂装

    即刻上底漆

    钢材表面干燥,不存在返锈窗口期,检验一通过,底漆就能跟上。

An operator in orange high-visibility coveralls and blast hood stands under a riveted bridge girder in a containment

在涂有含铅漆的钢材上,海绵磨料不会让废料变得无害,它减少的是废料的量:残物随海绵磨料一起回收,由振筛机分离出来,送去按危险废物处置的只有细粉,而不是成吨的废磨料。

应用说明

含铅漆清除 · 桥梁与钢结构

application note
开始试用
试用 EcoSponge Blast
就在你自己的工件上。

告诉我们你的本体、涂层和目标粗糙度。我们推荐合适的档位,寄出试用样品,并附技术资料和SDS安全数据表。